Photomultiplier tubes (PMT) have a given output impedance, which is defined by the internal geometrical structure. On the other hand, every electronics, which is used to process the signals of the PMT has an input impedance. Due to the impedance mismatch part of the signal gets reflected back into the PMT and hence is lost. A very simple approach to match the input to the output impedance is a resistor, but also in this case part of the signal gets lost in the resistor.
Solution
Our solution minimizes the signal loss by matching the output impedance to the input impedance in an advanced way. By this it is possible to minimize the signal loss. At the same time the impact on the signal timing is minimal.
With this solution it is possible to match the PMT output impedance (in the image above 150 Ω) to normal 50 Ω electronics as well as to custom electronics with low (e.g. 3 Ω) impedance.
Advantages
Impedance Matching of PMT and connected electronics
Higher charge output, because less signal is lost
Conserved timing, almost no shaping in output signal
Possibility to separate PMT ground from other grounds
Status
Patent application at the German Patent and Trade Mark Office. The patent application pending is not yet published in the Patent Gazette. Only after the first publication of the patent application, the applicant can derive rights therefrom and can especially claim compensation from third parties.
Proof of concept and prototype
RWTH Aachen University is looking for partners for patent exploitation and for research partners for joint development and contract research.
RWTH Technology #2026
Field of application Electronic devices
Keywords #Photomultiplier; #impedance matching; #low signal loss; #custom electronics
